Finally got it out of the box, setup, explore the new features, amazed at those, and the extreme exhaust fan noise.

So what do I do with this monster that I couldn’t do with my ender 3? yup bag clips.

  • @TerraRoot@sh.itjust.worksOP
    link
    fedilink
    English
    02 months ago

    I’ve been doing some light research and i think it’s possible to run the stock fan slower and turn it off when not printing, but it’s unclear whether i’d have to plug the fan into a different header or not.

    Because the full info is in a private facebook group :bleugh:

    • @SzethFriendOfNimi@lemmy.world
      link
      fedilink
      English
      12 months ago

      Is it running Klipper or something else?

      In Klipper I have my controller board fan set to speed up only when there’s any active heaters or stepper drivers?

      E.g. fires up only when moving/heating or printing but not when idle. Even then it’s set to a reasonable 80% threshold.

      • @TerraRoot@sh.itjust.worksOP
        link
        fedilink
        English
        12 months ago

        It has klipper but not mainline klipper, looking at some firmware updates that might automagically fix this. gotta confirm what I currently have.