ROLLER

@user_6282638282 yeah, when its stuck hard sometimes it just wont come off. Ive killed a couple of beds like that. Basically do the opposite of getting better adhesion! Thinner first layer, lower temps, larger nozzle offset etc

@user_6282638282 I’ve had similar problems. It may be the coating has been removed from the bed. It happens when filament sticks too much, PETG is pretty bad for it. I tend to leave my bed to cool so the piece pops off itself. That doesnt always work. Following other advice to reduce adhesion like bed temp, offset etc may work.

@Imgonnatrythis @cm0002 octoprint has a useful Telegram plug in so i can see my print updates on my phone. I’d recommend

@cyberwolfie I tried with 1.0 and it really does appear to do the same things, so you will get what you need. I do need to try changing myself… Not sure when though.
Good luck with the project. I’ll hopefully see it up on Lemmy.

@cyberwolfie @Imgonnatrythis agree that Freecad learning curve is steep. I balked and ended up using Fusion360 (non commercial). I found it to be more friendly and have tutorials I liked. I like the idea of using an LLM to code in something like OpenSCAD though.

@KiloGex you need to tune your printer for the cold. Exposure times need to be longer and rise times slower. The set reaction is slower and the resin more viscous.
I managed with my printer in similar temps. Clean up is also more difficult in lower temps. I don’t have the link I used, others may suggest.